Then you can pry the control panel frame from the main plastic cover. Remove these two screws.Next, flip the panel over and release the two locking tabs on both of the top corners. Set the control panel face up and locate the two screws below the front face panel. Also, unplug the wire harness at the on/off switch by pulling the blue wire harness free. The control panel is now completely unconnected. Then remove the grounding wire by prying the release lever free. But if you want to make sure you’re plugging the wires into the right places, take a picture before you begin disassembly so you have a guide to refer to.Next, remove the wire harness for the door switch in the middle of the control panel. The harnesses only plug into their unique ports, so you don’t have to worry about incorrect assembly later. Release the wire harnesses in the top right section of the control panel. Rotate it without stretching the wires so you can see the inside. Make sure you hold the control panel in place against the door so it doesn’t fall apart when the last screw comes out. Close the door and pull the control panel free. Then remove the screws along the interior top of the door. Remove the two screws at the top of the sides of the sides of the door to release the frame. The two corner baffles may fall off, so just set them aside until later.After that, open door at a forty-five-degree angle. Then slide the top free of the groove and pull it out. Then shut the door.Next, remove the front panel by lifting up the bottom edge at an angle. Remove the six screws on each side of the internal perimeter of the door. Dismantle the door.įirst, lower the door. So disconnect the appliance from its source of power to keep yourself and the surrounding area safe. Unplug the dishwasher.ĭuring the course of this repair, you will be unplugging wires. Then follow these steps to remove and replace the part. If you want to make the repairs yourself, order replacement part #00432779 for your Bosch dishwasher. Once the screw holes are stripped, it’s time to replace the part. So if the control panel starts to wiggle and it won’t stay firmly in place, check the frame. The control panel frame is what holds your whole control panel together.
0 Comments
Leave a Reply. |